(Yield) Maps - StellarSupport - John Deere

stamp prior to when you did the calibration.
239
Field Maps
• If you are unsure about the time stamps, but you know where the
calibration was done in the field, check one file and click Preview. The
data file location will be the colored yield sites on the field map.
5. Click Calibrate; a Calibration window will open.
6. To calibrate yield, select By Calibration Factor in the Yield Calibration
box. The Old calibration number (as used and recorded in the file) will be
listed. Enter the New calibration factor.
• The formula for determining the New Cal factor is:
Weight of grain shown on display
Displayed Cal Factor X ----------------------------------------------------- = New Cal Factor
Net Weight of grain from scale ticket
7. To calibrate moisture, enter the % Increase or Decrease in the Moisture
Calibration box.
8. Click OK.
Calibrate by Field Totals
The total weight and average moisture (of your field) values are found on your
elevator weigh tickets.
Calibrate by field totals:
1. From the field map that needs to be calibrated, click Layers .
2. Select Edit for the yield or moisture point layer.
• If it is not in the chooser, Add it.