(Yield) Maps - StellarSupport - John Deere

• You need to click on the operation name itself to highlight the entry.
2. Click Edit Product.
3. In the Changed Product Name column, select the new product.
131
Using the PC Card
• If it is not defined, click New. The corresponding Setup tab will open. Enter the new
data and click OK.
4. Verify the new product is selected in the Changed Product Name column.
5. Click Change to update the tank mix.
Once all the products are defined, you need to see if there is already a predefined tank mix
that matches the components of the mix on the card.
Begin by selecting a new mix from the drop down box (bottom section of the Edit Tank Mix
Entry screen). If the two mixes match, click Change to change the individual tank mix;
click Change All to change all tank mix entries by the same name. JDOffice will verify that
are no differences. If it accepts the change, it means that the exact tank mix, as recorded
on the card, has already been defined in Setup - it was simply called a different name on
the card.
If you get the following error, JDOffice has determined that the two mixes are not identical.
• If you feel the mixes match exactly - as listed in the two boxes, verify the mix rates
(located under each tank mix name). If these rates differ, you will be forced to
create a new tank mix to unload the data.
At this point you can either edit a pre-existing mix to fit your recorded data, or you can