(Yield) Maps - StellarSupport - John Deere

Edit the Load
121
Using the PC Card
If you enabled CropTracer on the GreenStar Display (Setup>Field
Doc>Page2>CropTracer), loads will be listed in the Data to Edit
section.
A load is created in a seeding operation each time seeds are
loaded into the planter. Most loads will only contain one lot number,
but two lots is not uncommon (there is a two lot limit per load).
Because multiple varieties planted simultaneously are not able to
be documented yet, all loads will contain just one variety; therefore
all lots within that load will also be the same variety.
Note: If you manually entered the lot information into the GreenStar Display,
you will be able to edit, delete or create new lot information to correct any
mistakes.
To document multiple varieties, you will need to select an additional load when you add
the new seeds into the hoppers.
Edit the Load Data:
1. In Data to Edit, select Load.
2. In the Load list, select the load number you want to edit.
3. Click Edit.
The Edit Load Entry screen will display all the lot data that is contained in that load.
If you forgot to enter additional seed bags, and know the date/time and location, enter a
New lot entry for the known load number.
If you delete lot information that was entered manually on the GreenStar Display, it will be
deleted permanently.