(Yield) Maps - StellarSupport - John Deere

In the Edit Entry window, you can:
Change the flag:
119
Using the PC Card
4a. In the Changed Flag column, select the new flag.
4b. In the Changed State column, select On or Off.
4c. Click Change to change the individual flag; click Change All to change all flags
by the same name.
Delete the flag:
4a. Click Delete.
• If there is only one operation in a file, the Delete button will be disabled.
Create a new flag:
4a. Click New. The Flag Setup tab will open.
4b. Enter the new flag data (refer to “Flag Setup” on page 84).
4c. Verify the new flag is selected in the Changed Flag column.
4d. In the Changed State column, select On or Off.
4e. Click Change to change the individual flag; click Change All to change all flags
by the same name.
Edit the Implement
When Implement is selected from the Data to Edit list, the screen
will list the implements that were used in the field (as selected on
the GreenStar Display).
For each operation listed in the Data to Edit window, a
corresponding implement will be listed for it. Implements
correspond to a specific operation - not to the entire file.
All invalid entries must be renamed.
There will be multiple entries of the same implement if you turned your equipment on and
off while working in the field. These duplicates will combine into one when the data is
unloaded from the PC Card.