(Yield) Maps - StellarSupport - John Deere

Data to Edit
115
Using the PC Card
The Data to Edit section of the Edit Data Files screen is used to
pick the field data you want to edit. Mistakes made in the field,
including invalid entries, need to be corrected on this screen.
Invalid entries are created when the user selects an Unknown pick
on the GreenStar Display. They will appear in red, and JDOffice will
not let you unload the PC Card until they are corrected.
If you accidentally make the wrong selection in the GreenStar Display, you can use the
Edit Data Files screen to reassign the correct choice. To verify your selections, the data
can be viewed as filters in the field preview window on the right.
Depending on the type of file you are unloading, several kinds of data can be edited. As
with farms and fields, you may need to assign names to unknowns, or rename the
selection made in the field. If the name you want to change it to is not listed, it means that
it is not defined in Setup.
After you have made the corrections, click Unload.
If you have made changes to the data and decide to start over, click the Reset button; your
data will be restored to the exact state it was in before you started editing.
Duplicate Operation Error
An operation cannot contain duplicate product types for the same operation within one
task. If duplicates are detected, you will receive an error; the duplicates must be eliminated
before the file can be unloaded.
If you receive the Duplication operation error, there are several ways to fix it:
1. Rename one of the product types. This will allow you to unload both entries (and view
them in reports and on maps), although it will cause some of your data to have the
product type labeled incorrectly.
2. Rename the task. On the Unload PC Card window, uncheck the Unload all data files
for selected field and type box and unload each of the files individually. On the Edit
Data Screen window, rename the task in one of the files.
3. Delete one of the pairs and unload the file. After doing so, manually create a New
Operation Layer (Whole Field) using the naming convention from the deleted file (i.e.
same task, operation type, product type and product name)