Hibond Catalogue Book under process - Hi-Bond Bearings Pvt. Ltd.

3. Thrust Washers :
Thrust Washers are generally supplied in standard size and 0.005” , 0.010”, 0.015”, 0.020” (0.1, 0.25, 0.4, 0.5 mm)
oversizes.
When the thrust surface of the crankshaft is ground at the time of journal grinding the wall thickness of replacement
thrust washers is required to be more than standard size to maintain the correct end float or thrust clearance.In such
cases oversize thrust washers are used. These thrust washers can either be used as supplied or can be maintained
to any required size upto next lower oversize.
4. Thrust Main Bearings (Flanged) :
For the reason explained above, the overall length of the prefinished and semifinished undersize flanged bearings is
kept more by providing additional bearing material on the flanges. These bearings are made to the same precise
tolerance on length as bearings with standard length. Therefore, bearings plus on length can be used as supplied or
can be machined upto next undersize width to obtain the correct end float.
In most of the Hibond replacement undersize flanged bearings the overall length is kept oversize in steps of 0.010”
(0.25 mm), 0.020” (0.5 mm) and 0.040” (1 mm) than standard size for different undersize ranges.
For Private Circulation :-
OE Reference No. And Other Reference No. Are Only For Cross Reference
5