raised floors - Butech

structure
The structure is made up of pedestals and stringers, which support the floor covering and ensure the necessary height and rigidness.
pedestals
100% galvanised steel structure. This pedestals dictate the floor
height according to the project requirements. Each pedestal
incorporates a series of plastic noise-reduction heads fitted with
four positioning lugs.
One of the main advantages of the pedestal system is that it
is fitted with a 14 mm threaded bolt that can be adjusted to
accommodate different floor height requirements.
stringers
Like the pedestals, the stringers are made entirely of galvanised
steel. Their main function is to increase the strength of the floor.
They are covered with special noise-reduction strips.
The nominal heights and the way of the pedestals have been selected for greater overlap between two successive pedestals using a long screwed bolt.
Because of this, it has obtained a greater range of height adjustment for each type of pedestal (nominal - / +50 mm) with the ability to better adapt to
the unevenness of the floor, without resorting constantly to systematic measurements.
From the point of view of performance, it presents a high resistance to bending vertical load and / or eccentric, thanks to a screwed bolt M16 section, a
tube of diameter 20 mm of thickness of 2 mm, internally calibrated to obtain a coupling with smaller tolerances and therefore less spaces and a direct
connection between the screwed bolt of the disc base and tube, without need of interposing deformable plastic elements.
To ensure electrical continuity of the pedestal, the base disc has been drilled to accommodate the screw and nut for electrical connection.
In the disc of base have been added 4 holes of 8,5 mm and 3 holes of 6,5 mm, at the height of the radial nerves, to enable and facilitate the injection of
fluid adhesive on the back of the base when the pedestal is already installed.
When necessary, and with a simple intervention without special tools, the structure offers the possibility to adjust the height of the pedestal shortening
the tube if necessary.
12