2010 Construction and Material Specifications - Ohio Department of ...

732.12
Fit poles with a welded-on cast or plate steel base designed to mount on an
anchor bolt foundation and ensure that each pole includes the furnishing of anchor
bolts and conduit ells for installation in the foundation. Furnish at least one 2-inch
(50 mm) diameter conduit ell for installation in each foundation. Furnish conduit
ells made from steel complying with 725.04; however, if they connect to nonmetallic
conduit, ensure that they are of the same non-metallic material.
Use steel anchor bolts conforming to ASTM F1554, Grade 105 and galvanized
according to 711.02. Ensure that the galvanizing extends at least 2 inches (50 mm)
beyond the threads. Ensure that ends either are bent or have a drilled and tapped
steel plate as shown on the plans.
Ensure that the poles include a handhole near the base oriented as required.
Reinforce the handhole with a welded-on steel frame with a grounding lug and fit
it with a cover plate fastened by stainless steel screws. Ensure that the poles also
include a cable and wire support J-hook welded near the top and a removable pole
cap. Design poles and arms so their interiors conceal wiring and their mast arms
include grommeted wire outlets for the signal heads. Furnish hanger clamps with
clevises on the mast arms for the signal heads as required. Ensure that arm caps
are made of steel and cover at least 50 percent of the end area.
Ensure that signal poles combining provisions for roadway lighting include an
additional handhole located opposite the mast arm flange with the poles’ J-hook
located above.
Furnish pedestrian pushbutton access holes and blind half couplings for
controllers and pedestrian signal heads as required. Plug any unused holes.
Furnish certified materials according to Supplement 1094.
732.12 Strain Poles. Furnish signal strain poles for the attachment of span
wire that are steel tapered tubes according to the requirements of 732.11. Ensure
that all poles include a removable pole cap, and messenger wire clamps with clevis
and shackle unless otherwise specified.
Furnish anchor bolt foundation type strain poles that include a welded-on cast
or plate steel base, bolt covers, a handhole, and a J-hook, as required by 732.11,
and that also include at least one 2-inch (50 mm) cable entrance with a
weatherhead and a welded blind half-coupling. Ensure that the poles include the
furnishing of anchor bolts and conduit ells for installation in the foundation.
Furnish at least one 2-inch (50 mm) diameter conduit ell for installation in each
foundation. Furnish steel conduit ells that comply with 725.04; however, if they
connect to non-metallic conduit, ensure that they are of the same non-metallic
material.
Furnish certified materials according to Supplement 1094.
732.13 Wood Poles. Furnish wood poles that conform to ANSI 05.1
“Specifications and Dimensions for Wood Poles”, that are made of Southern Pine
or Western Red Cedar, and that are full-length pressure treated according to
725.19.
732.14 Down Guy Assemblies. Furnish down guy assemblies according to
725.19. Furnish insulators and hardware that conform to 732.18. Furnish
812