2010 Construction and Material Specifications - Ohio Department of ...

Furnish a visor with each signal section.
799
732.03
Cable entrance adapters shall be of the tri-stud type with stainless steel
hardware. A neoprene gasket placed under the clamp washer in the top signal
section shall effectively seal the entrance adapter on the signal to make a
weatherproof connection and shall have a minimum thickness of 3/32 inch (2.5
mm).
Furnish materials according to the Department’s Qualified Products List
(QPL).
732.03 Vehicular Signal Heads, Optically Programmed, 8-inch (200 mm)
Lens. Optically programmed signal heads with 8-inch (200 mm) lenses consist of
a conventional 8-inch (200 mm) signal housing, reflector and door; and an
extension portion which is attached in place of a conventional lens and which
contains a lens system capable of optical programming. Furnish the conventional
signal housing with reflector and wiring, and the optical programmable extension
portion according to the applicable requirements of 732.01 and 732.02.
Furnish a cutaway visor with each signal section. Ensure that the signal
sections include an incandescent lamp or when specified, a LED lamp.
Programming the 8-inch (200 mm) lens type head requires the use of an
extender tool as recommended by the manufacturer to move the extension portion
to the side to expose the optics for programming purposes.
Furnish materials according to the Department’s Qualified Products List (QPL).
732.04 Signal Lamps.
A. Optically Programmed and Pedestrian Signal Incandescent Lamps.
Ensure that optically programmed and pedestrian signal incandescent lamps
conform to the ITE A Standard for Traffic Signal Lamps and Table 732.04-1.