05.01.2013 Views

CCNA Cisco Certified Network Associate Study Guide - FTP Server

CCNA Cisco Certified Network Associate Study Guide - FTP Server

CCNA Cisco Certified Network Associate Study Guide - FTP Server

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

622 Appendix B � Configuring the Catalyst 1900 Switch<br />

6. From 1900B, type show vlan to see if the VLAN information was<br />

propagated from the 1900A switch.<br />

1900B#sh vlan<br />

VLAN Name Status Ports<br />

--------------------------------------<br />

1 default Enabled 1-12, AUI, A, B<br />

2 Sales Enabled<br />

3 Management Enabled<br />

4 Engineering Enabled<br />

5 Marketing Enabled<br />

1002 fddi-default Suspended<br />

1003 token-ring-defau Suspended<br />

1004 fddinet-default Suspended<br />

1005 trnet-default Suspended<br />

--------------------------------------<br />

Notice that it found all the VLANs, but that all of 1900B’s switch ports<br />

are in VLAN 1. Unless you tell it differently, all ports are always in VLANs.<br />

You have to set the ports at each switch. (VTP sends VLAN information, not<br />

port information.)<br />

Lab B.7: Configuring Inter-VLAN Routing with ISL<br />

Now that we have configured our VLANs and set up VTP domain information<br />

so both switches have the same VLAN configurations, we need to configure<br />

the 2600 router to support inter-VLAN routing.<br />

1. Plug the 2600 into one of the FastEthernet ports on either switch. It<br />

doesn’t matter where you plug the router into the switch fabric.<br />

2. Configure the switch port as a trunk port.<br />

1900A#config t<br />

1900A(config)int f0/027<br />

1900A(config-if)# trunk on

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!