CCNA Cisco Certified Network Associate Study Guide - FTP Server

614 Appendix B � Configuring the Catalyst 1900 Switch
7. Set the IP address, subnet mask, and default gateway of the switch by
typing the following:
config t
ip address 172.16.10.3 255.255.255.0
ip default-gateway 172.16.10.1
8. Type show ip to see the new configuration.
9. Ping Router A by typing ping [ip address] at the CLI.
10. Type show mac-address-table to view the filter table used in the switch
to make forwarding decisions.
11. Type show interfaces to gather statistics on all interfaces.
12. Type show int ? to see the available Ethernet and FastEthernet
commands.
13. Type sho int Ethernet ? to choose the card 0. means only one
card with 12 or 24 ports.
14. Type sh int e 0/? to see all available interfaces.
15. Type sh int e 0/2 to see statistics for interface Ethernet 2.
16. Type delete nvram to delete the startup-config.
You cannot view the startup-config, only the running-config. Also, the runningconfig
is saved automatically to NVRAM.
Lab B.2: 1900 Switch Operations
This second lab will have you set the passwords, IP addresses, and port security
available on a 1900 switch.
1. Type K from the 1900A or 1900B switch console to enter CLI mode.
2. Type en or enable to enter privileged mode.