CCNA Cisco Certified Network Associate Study Guide - FTP Server

612 Appendix B � Configuring the Catalyst 1900 Switch
Written Lab
In this lab, you will write out the commands to answer the questions.
1. Write the command to display the configuration of the switch.
2. Write the command to see the IP configuration of the switch.
3. Write the command to see the MAC filter table.
4. Write the command to set port e0/2 to a secure table size of 1.
5. Write the command to assign MAC address 1234.4567.8912 to port
e0/1 as a permanent address.
6. Write the command to remove the permanent address you just added
to port e0/1.
7. Write the command to view the statistics of port e0/5.
8. Write the commands to create three VLANs: Purchasing, Sales,
and MIS.
9. Write the command to assign ports 2 and 3 to Sales, 4 and 5 to Purchasing,
and 6 and 7 to MIS. Use only static assignments.
10. Write the command to make your switch a VTP client.
11. Write the command to set your switch to be a transparent switch.
12. Write the command that will show the VTP status of your switch.
13. Write the command that will put interface B into auto trunk mode.
14. Write the command to view all VLAN information on a switch.
15. Write the command to set interface 5 to VLAN 2.