05.01.2013 Views

CCNA Cisco Certified Network Associate Study Guide - FTP Server

CCNA Cisco Certified Network Associate Study Guide - FTP Server

CCNA Cisco Certified Network Associate Study Guide - FTP Server

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

584 Appendix B � Configuring the Catalyst 1900 Switch<br />

In the configuration example above, I set the description on both a 10Mbps<br />

port and a 100Mbps port.<br />

Viewing Descriptions<br />

Once you have configured the descriptions you want on each interface, you<br />

can then view the descriptions with either the show interface command or<br />

the show running-config command.<br />

Todd1900EN#sh int e0/1<br />

Ethernet 0/1 is Suspended-no-linkbeat<br />

Hardware is Built-in 10Base-T<br />

Address is 0030.80CC.7D01<br />

MTU 1500 bytes, BW 10000 Kbits<br />

802.1d STP State: Forwarding Forward Transitions: 1<br />

Port monitoring: Disabled<br />

Unknown unicast flooding: Enabled<br />

Unregistered multicast flooding: Enabled<br />

Description: Finance_VLAN<br />

Duplex setting: Half duplex<br />

Back pressure: Disabled<br />

Todd1900EN#sh run<br />

Building configuration...<br />

Current configuration:<br />

hostname "Todd1900EN"<br />

!<br />

ip address 172.16.10.16 255.255.255.0<br />

ip default-gateway 172.16.10.1<br />

!<br />

interface Ethernet 0/1<br />

description "Finance_VLAN"<br />

!<br />

[output cut]<br />

Notice in the above switch output that the sh int e0/1 command and the show<br />

run command both show the description command set on an interface.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!