CCNA Cisco Certified Network Associate Study Guide - FTP Server

580 Appendix B � Configuring the Catalyst 1900 Switch
switch, use the command ip address. The default gateway should also be
set using the ip default-gateway command.
The switch output below shows an example of how to set the IP address
and default gateway on a 1900 switch.
Todd1900EN#config t
Enter configuration commands, one per line. End with
CNTL/Z
Todd1900EN(config)#ip address 172.16.10.16 255.255.255.0
Todd1900EN(config)#ip default-gateway 172.16.10.1
Todd1900EN(config)#
Once you have your IP information set, use the show ip command to verify
your changes.
Todd1900EN#sh ip
IP Address: 172.16.10.16
Subnet Mask: 255.255.255.0
Default Gateway: 172.16.10.1
Management VLAN: 1
Domain name:
Name server 1: 0.0.0.0
Name server 2: 0.0.0.0
HTTP server : Enabled
HTTP port : 80
RIP : Enabled
Todd1900EN#
To change the IP address and default gateway on the switch, you can
either type in new addresses or remove the IP information with the no ip
address and no ip default-gateway commands.
Configuring Switch Interfaces
It is important to understand how to access switch ports. The 1900 switch
uses the type slot/port command. For example, Ethernet 0/3 is 10BaseT
port 3. Another example would be FastEthernet 0/26. This is the first of the
two FastEthernet ports available on the 1900 switch.
The 1900 switch type slot/port command can be used with either the
interface command or the show command. The interface command