CCNA Cisco Certified Network Associate Study Guide - FTP Server

Cisco 1900 IOS Configuration Commands 575
and then enter global configuration mode by using the config t command.
The following output shows an example of how to get into enable mode and
then into global configuration mode.
1 user(s) now active on Management Console.
User Interface Menu
[M] Menus
[K] Command Line
[I] IP Configuration
Enter Selection: K
CLI session with the switch is open.
To end the CLI session, enter [Exit].
>enable
#config t
Enter configuration commands, one per line. End with CNTL/Z
(config)#
Once you are in global configuration mode, you can set the user mode and
enable mode passwords by using the enable password command. The following
output shows the configuration of both the user mode and enable
mode passwords.
(config)#enable password ?
level Set exec level password
(config)#enable password level ?
Level number
To enter the user mode password, use level number 1. To enter the enable
mode password, use level mode 15. Remember the password must be at least
four characters, but not longer than eight characters. The switch output
below shows the user mode password being set and denied because it is more
than eight characters.
(config)#enable password level 1 toddlammle
Error: Invalid password length.
Password must be between 4 and 8 characters