05.01.2013 Views

CCNA Cisco Certified Network Associate Study Guide - FTP Server

CCNA Cisco Certified Network Associate Study Guide - FTP Server

CCNA Cisco Certified Network Associate Study Guide - FTP Server

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

522 Chapter 10 � Wide Area <strong>Network</strong>ing Protocols<br />

Written Lab<br />

1. Write the command to see the encapsulation method on serial 0 of a<br />

<strong>Cisco</strong> router.<br />

2. Write the commands to configure s0 to PPP encapsulation.<br />

3. Write the commands to configure a username of todd and password of<br />

cisco that is used on a <strong>Cisco</strong> router.<br />

4. Write the commands to enable CHAP authentication on a <strong>Cisco</strong> BRI<br />

interface.<br />

5. Write the commands to configure the DLCI numbers for two serial<br />

interfaces, 0 and 1. Use 16 for s0 and 17 for s1.<br />

6. Write the commands to configure a remote office using a point-topoint<br />

subinterface. Use dlci 16 and IP address 172.16.60.1/24. The<br />

IPX network is 16.<br />

7. Write the commands to set the switch type of basic-ni on a <strong>Cisco</strong><br />

router BRI interface.<br />

8. Set the switch type on a <strong>Cisco</strong> router at the interface level.<br />

9. Write the command that will specify interesting traffic to bring up the<br />

ISDN link. Choose all IP traffic.<br />

10. Write the commands necessary to apply the command that you specified<br />

in question 9 to a <strong>Cisco</strong> router.<br />

11. Write the commands to configure the dialer information on a <strong>Cisco</strong><br />

router.<br />

12. Write the commands to set the dialer load-threshold and the idle-time<br />

percentage.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!