CCNA Cisco Certified Network Associate Study Guide - FTP Server

520 Chapter 10 � Wide Area Networking Protocols
Command Description
frame-relay interface-dlci Configures the PVC address on a
serial interface or subinterface
frame-relay lmi-type Configures the LMI type on a
serial link
frame-relay map protocol
address
Creates a static mapping for use
with a Frame Relay network
interface s0.16 multipoint Creates a multipoint subinterface
on a serial link that can be used
with Frame Relay networks
interface s0.16 point-topoint
Creates a point-to-point
subinterface on a serial link that
can be used with Frame Relay
isdn spid1 Sets the number that identifies the
first DS0 to the ISDN switch
isdn spid2 Sets the number that identifies the
second DS0 to the ISDN switch
isdn switch-type Sets the type of ISDN switch that
the router will communicate with.
Can be set at interface level or
global configuration mode.
no inverse-arp Turns off the dynamic IARP used
with Frame Relay. Static mappings
must be configured.
ppp authentication chap Tells PPP to use CHAP
authentication
ppp authentication pap Tells PPP to use PAP
authentication