CCNA Cisco Certified Network Associate Study Guide - FTP Server

Answer to Review Questions
Answer to Review Questions 437
1. C. Sequenced Packet Exchange works with IPX to make a connectionoriented
service at the Transport layer.
2. A, D. Only a local NetWare server or a router can respond to a GNS
request. A remote server will never see the request.
3. C. IPX RIP and SAP are broadcast every 60 seconds by default by
every router and server on the internetwork.
4. A. The only correct answer is A. The command to create a subinterface
is int type int.number (int e0.10, for example).
5. B. The IPX address is four bytes for the network and six bytes for the
node address, in hex.
6. C. It is possible that the frame types on a LAN interface are not the
same between the server and the clients. This would cause the clients
to not see the server.
7. A, B. You can either use the secondary command or create subinterfaces
on a LAN interface to create multiple virtual IPX networks.
8. C. The command show ipx traffic shows all the RIP and SAP
information received on the router, but the command show ipx
interface shows the RIP and SAP information received only on a
certain interface.
9. D. Show ipx servers lets you see if the router is hearing the server
SAPs. Although show ipx traffic and show ipx interface show
SAP information sent and received, they don’t show from whom it is
received.
10. C, E. The command show interface does not show you the IPX
address of an interface, it only shows you the IP address. Only the
commands show ipx interface and show protocols show the IPX
address of the routers’ interfaces.