CCNA Cisco Certified Network Associate Study Guide - FTP Server

424 Chapter 8 � Configuring Novell IPX
Written Lab
In this section, you will write out the answers to the following IPX
related questions.
1. Write the command that lets you view your configured routed protocols
on your router.
2. Write the command to enable the IPX-routed protocol.
3. Write the command that enables IPX on individual interfaces. Configure
an Ethernet 0 interface with IPX network 11, Token Ring with
IPX network 15, and serial 0 with IPX network 20.
4. Write the command that lets you see the IPX routing table.
5. Write the two commands you can use to see the IPX address of an
interface.
6. Write the two commands that will find your neighbor’s IPX address.
7. Add the Ethernet_II frame type to an Ethernet 0 interface, but don’t
use a subinterface to accomplish this. Use IPX network number 11a.
8. Add the 802.2 and SNAP frame types to an Ethernet 0 interface using
subinterfaces. Use 11b and 11c IPX network numbers.
9. Write the commands that you can use to verify your IPX
configuration.