CCNA Cisco Certified Network Associate Study Guide - FTP Server

416 Chapter 8 � Configuring Novell IPX
Show IPX Interfaces
RIP: 1 RIP requests, 0 RIP replies, 6 routes
8 RIP advertisements received, 230 sent
12 RIP flash updates sent, 0 RIP format errors
Echo: Rcvd 0 requests, 5 replies
Sent 5 requests, 0 replies
0 unknown: 0 no socket, 0 filtered, 0 no helper
0 SAPs throttled, freed NDB len 0
Watchdog:
0 packets received, 0 replies spoofed
Queue lengths:
IPX input: 0, SAP 0, RIP 0, GNS 0
SAP throttling length: 0/(no limit), 0 nets
pending lost route reply
--More—
Remember that the show ipx traffic command shows you the statistics
for IPX RIP and SAP information received on the router. If you wanted to
view the statistics of RIP and SAP information received only on a specific
interface, use the next command we discuss: show ipx interface.
The show ipx interfaces command gives you the interface status of IPX
and the IPX parameters configured on each interface. The show ipx
interface e0 command shows you the IPX address and encapsulation type
of the interface. If you use the show interface e0 command, remember
that it does not provide the IPX address of the interface, only the IP address.
2501A#sh ipx int e0
Ethernet0 is up, line protocol is up
IPX address is 10.0000.0c8d.5c9d, NOVELL-ETHER [up]
Delay of this IPX network, in ticks is 1 throughput 0
link delay 0
IPXWAN processing not enabled on this interface.
IPX SAP update interval is 1 minute(s)
IPX type 20 propagation packet forwarding is disabled
Incoming access list is not set
Outgoing access list is not set