CCNA Cisco Certified Network Associate Study Guide - FTP Server

356 Chapter 7 � Managing a Cisco Internetwork
Closing Telnet Sessions
You can end Telnet sessions a few different ways. Typing exit or
disconnect is probably the easiest and quickest.
To end a session from a remote device, use the exit command.
2509# (I pressed enter twice here)
[Resuming connection 2 to 192.168.0.148 ... ]
switch>exit
[Connection to 192.168.0.148 closed by foreign host]
Todd2509#
To end a session from a local device, use the disconnect command.
Todd2509#disconnect ?
The number of an active network connection
WORD The name of an active network connection
Todd2509#disconnect 1
Closing connection to 172.16.10.2 [confirm]
Todd2509#
In this example, I used the session number 1 because that was the connection
to the 2501B router that I wanted to end. As explained earlier, you can use
the show sessions command to see the connection number.
If you want to end a session of a device attached to your router through
Telnet, you might want to first check if any devices are attached to your
router. Use the show users command to get that information.
2501B#sh users
Line User Host(s) Idle Location
* 0 con 0 idle 0
1 aux 0 idle 0
2 vty 0 idle 0 172.16.10.1