CCNA Cisco Certified Network Associate Study Guide - FTP Server

284 Chapter 5 � IP Routing
Written Lab
Write the answers to the following questions.
1. Create a static route to network 172.16.10.0/24 with a next hop gateway
of 172.16.20.1 and an administrative distance of 150.
2. Write the commands used to turn RIP routing on in a router and
advertise network 10.0.0.0.
3. Write the commands to stop a router from propagating RIP information
out serial 1.
4. Write the commands to create an AS 10 with IGRP in your 172.16.0.0
network.
5. Write the commands to configure a default route on a router to go to
172.16.50.3.
6. What works with triggered updates to help stop routing loops in distance-vector
networks?
7. What stops routing loops in distance-vector networks by sending out
a maximum hop count as soon as a link fails?
8. What stops routing loops in distance-vector networks by not resending
information learned on an interface out that same interface?
9. The ________ command controls the load balancing between the best
metric and the worst acceptable metric.
10. What command is used to send routing updates as they are sent and
received on the router to the console session?