CCNA Cisco Certified Network Associate Study Guide - FTP Server

272 Chapter 5 � IP Routing
2501B
2501C
To configure 2501B, you need, once again, to turn on IGRP using AS 10.
2501B#config t
Enter configuration commands, one per line. End with
CNTL/Z.
2501B(config)#router igrp 10
2501B(config-router)#netw 172.16.0.0
2501B(config-router)#^Z
2501B#
The last router is 2501C; you need to use AS 10 as well.
2501C#config t
Enter configuration commands, one per line. End with
CNTL/Z.
2501C(config)#router igrp 10
2501C(config-router)#netw 172.16.0.0
2501C(config-router)#^Z
RouterC#
Verifying the IGRP Routing Tables
Once the routers are configured, you need to verify the configuration
with the show ip route command.
In all of the following router outputs, notice that the only routes to networks
are either directly connected or IGRP-injected routes. Since we did not
turn off RIP, it is still running in the background and taking up both router
CPU cycles and bandwidth. However, the routing tables will never use a RIPfound
route because IGRP has a better administrative distance than
RIP does.