Embedded Solutions

CompactPCI MEN
18
CompactPCI
D6 – 6U CompactPCI/PXI Pentium ® M SBC
■ Pentium ® M up to 2GHz
■ Prepared for dual Pentium ® M
■ 1-slot CompactPCI 64-bit/66MHz
■ System slot, peripheral slot
or stand-alone
■ Hot-swap and PICMG 2.16
support
■ Up to 8GB ECC DRAM
■ NAND Flash, SRAM
Processor
■ Single Pentium ® M Processor 760 at 2GHz
■ Single Pentium ® M LV Processor 738 at 1.4GHz
■ Single Pentium ® M ULV Processor 373 at 1GHz
■ Board architecture prepared for Dual
Pentium ® M
■ Passive heatsink
Chipset
■ Intel E7320/7520 and ICH6300
■ Front Side Bus: 400/533/800MHz
■ I/O bandwith
■ Up to 3 x 8 PCI Express lanes
■ 64-bit/66MHz PCI bus
■ 32-bit/33MHz PCI bus
■ High-end memory controller
■ Up to two registered memory DDR channels
operating in lock-step DDR2-400
■ Support of Intel ® x4 Single Device Data
Correction (x4 SDDC)
■ Support of standard SEC-DED (72, 64) ECC
on each channel
■ Support of automatic read retry on
uncorrectable errors
■ Hardware periodic memory scrubbing,
including demand scrub support
■ Memory mirroring (7520 only)
■ 6.4 GB/s bandwidth
Memory
■ 1 to 8GB ECC DDR2 400 memory
■ Up to two SO-DIMM banks
■ Graphics via FPGA (VGA front,
LVDS rear)
■ Up to 4 Gigabit Ethernet
■ Parallel ATA for
on-board hard disk
■ PC connectivity as available
in chipset
■ Further I/O individually via FPGA
■ 2 PMC slots
■ Prepared for 16GB (as soon as chips are avail.)
■ 4MB nonvolatile SRAM, linear addressing
■ 2MB BIOS/FPGA NOR Flash
■ Up to 1GB NAND Flash
(depending on chip availability)
CompactPCI Bus Interface
■ Universal bridge
■ System, peripheral or stand-alone operation
■ 64-bit/66MHz 3.3V VIO
PMC Slots
■ Two PMC slots up to 64-bit/66MHz, 3.3V VIO
■ PMC I/O module (PIM) support through J4
PCI Express
■ 2 x 4 lanes to connect local Gigabit Ethernet
controllers
■ 2 x 8 lanes for extension such as high-end
graphics (7520 only)
I/O
■ ICH6300
■ COM1, COM2 available with SA-Adpater
at the front or on rear I/O
■ Parallel ATA available on board for on-board
hard disk extension or rear I/O
■ USB 1.1/2.0: one channel at front,
two via rear I/O
■ Supports legacy keyboard/mouse SW
with USB devices
■ Real-time clock with 256B GoldCap backup
CMOS RAM
■ AC'97 via rear I/O
Product available Q IV / 2005
■ FPGA
■ 2D graphics controller (VGA upto XGA)
■ VGA connector at front, LVDS at rear
■ SRAM controller
■ NAND Flash controller for on-board Flash disk
■ Open for additional functions such as HDLC
controllers, CAN etc.
Connectivity
■ Debug/service on front I/O
■ USB
■ 100Mb Ethernet
■ VGA or serial lines
■ Network
■ Two 1Gigabit Ethernet channels compatible
with PICMG 2.16
■ Four 1Gigabit Ethernet channels at the front
instead of one PMC (option)
■ Ethernet controllers are connected by 8 PCIE
lanes to guarantee real throughput
BIOS
■ Industrial AWARD BIOS in NOR Flash
with recovery code
■ Save set-ups in Flash option
■ Boot from LAN and from USB capability
■ Extended set-up
■ Disk-less, keyboard-less and video-less
operation is supported
■ System, video and LAN BIOS shadowing
■ Advanced Configuration and Power
Interface (ACPI)
■ Intelligent System Monitoring
(thermal management)
■ Set-up console redirection to serial port
Supervisor
■ Support of a system management interface
via non-intelligent IPMI
■ Flexible Watchdog timers based on FPGA
■ Detection of restart cause from memory
Compliance
■ CompactPCI Core Specification PICMG 2.0 R3.0
■ CompactPCI Hot Swap Specification
PICMG 2.1 R2.0
■ CompactPCI System Management
PICMG 2.9 R1.0
■ CompactPCI Packet Switching Backplane
PICMG 2.16 R1.0
Mechanical Specifications
■ 6U, 4HP standard cPCI 6U board
Power Requirements
(Pentium ® M 1.4GHz, 1GB memory)
■ +5V (+5%, -3%), 6A typ.
■ +3.3V (+5%, -3%), 2A typ.
■ +12V, ±5%, only used for PMCs
■ -12V, ±5%, only used for PMCs
Operating System Compatibility
■ Windows XP, Windows XP Embedded,
Windows Server
■ Linux
■ VxWorks