Service Guide 2009 - Club Piscine
Service Guide 2009 - Club Piscine
Service Guide 2009 - Club Piscine
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The covers can now be removed. Depending on the model concerned there may be<br />
more than one cover to remove. There are several screws located on the perimeter<br />
of the covers. Some of these locate into the frame and some into the lugs within the<br />
cover itself. (Please be aware of the screw positions and types. Note: Before<br />
removing the covers from a machine powered by mains transformer it will be<br />
necessary to remove the power socket from the rear of the cover. To do this, remove<br />
all screws. Reach inside the cover and grip the power socket whilst removing the thin<br />
nut from the outside of the socket and carefully withdraw the socket and cable<br />
assembly. Reverse procedure when work complete.<br />
Section 2<br />
Speed Sensor & Resistance Mechanisms<br />
The speed of rotation is measured by a reed/proximity switch mounted next to the<br />
left rear drum. One or two small magnets are mounted in the rear drum and at each<br />
pass the switch opens and closes sending a ‘pulse’ to the meter either directly or via<br />
the control circuit board in the case of electromagnetically braked units.