Service Guide 2009 - Club Piscine
Service Guide 2009 - Club Piscine
Service Guide 2009 - Club Piscine
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
A<br />
Bremshey Treadmill s<br />
Folding Kit Installation Instructions<br />
** IMPORTANT: Before proceeding ensure the treadmill is unplugged and at 0 elevation.**<br />
Bremshey Treadmill Folding Kit BRETRFOLD-KIT<br />
Step 1:<br />
Important: One Side at a Time<br />
With treadmill in Folded Position, on level surface,<br />
slightly tilt and wedge treadmill to opposite side<br />
being worked on such that the rear wheel is off the<br />
floor. Remove wheel bracket from frame. Remove<br />
transport wheel from original bracket and install on<br />
the replacement bracket. Install new wheel<br />
bracket. Repeat on other side.<br />
Remove centre locking lever and spring, replace<br />
with new locking lever and spring<br />
Test unfolding motion, should be significantly<br />
smoother.<br />
Step 2: ONLY If Necessary<br />
With treadmill in Folded Position, remove gas<br />
shocks (one side at a time). Unscrew end from<br />
the gas shock, at canister end A, insert M8 lock<br />
washer and reinstall shock.<br />
Repeat on other side.<br />
Test unfolding motion.<br />
To unfold the treadmill, hold the handle bar firmly with the left hand, (opposite if left-handed) using your right hand,<br />
grasp the upper bar of the bed frame and push in towards the face of the console, step on the locking lever to lift it<br />
clear of the locking bar and then pull the bed forward toward you. **Note: Never fold treadmill when in an elevated<br />
position.