Service Guide 2009 - Club Piscine
Service Guide 2009 - Club Piscine
Service Guide 2009 - Club Piscine
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1.1 SERVICE MENUS<br />
1.1.1 Engineering Mode<br />
1 Enter the engineering mode after switching the treadmill POWER ON by<br />
pushing first „SELECT‟ and then „SPEED + and hold buttons pressed<br />
simultaneously approximately 5 seconds<br />
2 Sigma. The SPEED and DISTANCE windows shows the treadmill<br />
software version numbers, CALORIES and INCLINE/PULSE windows show the<br />
software design year and TIME window blank<br />
1 Delta. The SPEED window shows the treadmill software version number,<br />
TIME window shows the software design information<br />
2 Press „ENTER‟ to show LDU version number (Display control software)<br />
3 Press „ENTER‟ to show ISP version number<br />
4 Press „ENTER‟ to enter KM/MILE switch mode, 1 for KM, 0 for MILE<br />
Switch between the KM or MILE setting by pressing SPEED +/-or ELEVATION<br />
+/-** Sigma will toggle between 0 and 1 – Delta will not. Delta + = 1, -= 0<br />
5 Press „ENTER‟ to show total distance<br />
6 Press „ENTER‟ to show total usage hours<br />
7 Press „ENTER‟ to return to the normal mode<br />
1.1.2 Testing Mode<br />
1 Enter the testing mode after switching the treadmill POWER ON by pushing<br />
first „SELECT‟ and then „START‟ and hold buttons pressed simultaneously<br />
2 LED scanning mode for verifying display functionality<br />
3 Press „ENTER‟ to scan DATA LINES to verify display functionality<br />
4 Press „ENTER‟ to scan SACN LINES to verify display functionality<br />
5 Press „ENTER‟ to scan LED‟ s to verify display functionality<br />
6 After pressing „ENTER‟ the INCLINE/PULSE window shows “test” and the<br />
keypad functionality can be tested (the value displayed changes when a button is<br />
being pressed)<br />
6.Delta After pressing „ENTER‟ the INCLINE/PULSE window shows “P” and<br />
the heart rate functionality can be tested (the value displayed changes when the<br />
pulse increases)<br />
7. Press „ENTER‟ to enter IO mode<br />
Sigma:(INCLINE/PULSE display shows lift motor potentiometer value, SPEED<br />
reads speed from speed<br />
sensor )<br />
Delta:(TIME display shows lift motor potentiometer value, SPEED reads speed<br />
from speed sensor)<br />
Press ELEVATION +/-to vary elevation position and to test lift relay. This can also<br />
be used to lower lift motor if stuck in elevated position. CAUTION: DO NOT<br />
exceed potentiometer ranges as shown in Table 1 . Remove Safety Key<br />
from position before exceeding range.
Change language