Wireless Music System with Docking for iPod - Agk Nordic

TroUbleshooTIng
General
No power The AC connection is incomplete. Check all cords and cables..
The system does not respond when buttons are pressed. The built-in microprocessor may malfunction due to external electrical interference.
32
Unplug the AC power cord, and then plug it back in.
The system does not respond to the remote control The path between the remote control and the system’s remote sensor is blocked.
Clear the path. The batteries are flat. Replace the batteries.
No sound from the speakers The volume has been set too low, or the MUTE function is ON.
Increase the volume level or deactivate the MUTE function. Headphones are connected.
Speakers have become un-paired. Follow the speaker-pairing instructions on page 28.
You have added new speakers to the system, and they have not been paired.
Follow the speaker pairing instructions on page 28.
The wireless speakers have been placed too far away from the wireless main unit.
The normal operating range is about 100 ft indoors.
Move the speakers or the wireless main unit to reduce the operating range.
Audio interference is heard or the audio signal is interrupted. The wireless main unit or the wireless speakers are too close to interfering devices.
Follow the guidelines on page 8 to improve performance.
The red “Link” LED of speakers is flashing The wireless speakers are located too far away from the wireless main unit.
Radio Operation
The normal operating range is about 100 ft indoors.
Move the speakers or the wireless main unit to reduce the operating range.
The wireless main unit or the wireless speakers are too close to interfering devices.
Follow the guidelines on page 8 to improve performance.
Difficult to listen to broadcasts because of noise The FM antenna has not been properly extended and positioned. Extend it completely and try
another position.
Disc Playback Operation
Disc skips The disc may be scratched or dirt smeared. Clean or replace the disc.