Xerox Document Centre 440/432/420 User Guide

Access Rights
Quick Pathway
�Select [Access]
on the Control Panel
�Select [#] button on the
Control Panel
�Enter Owner PIN - see
NOTE
�Select [Additional
Setups] (if necessary)
�Select [Access Rights
Setups]
Personal Identification Numbers (PINs) and privileges are
assigned to users who need to access the Setup Tools. Up to
100 PINs, each between 4 and 16 digits long, may be
assigned. There are different levels of privileges, depending on
machine configuration:
- Key Operator
- System Administrator
- Auditron Administrator (DC440/432)
- Owner
NOTE: The factory default password is #22222. This
password is used initially, prior to new PINs being assigned.
To prevent unauthorized access, the default password should
be changed by a Xerox Service Representative.
Each privilege determines the right to set up the default
settings for a specified set of functions, as shown in the table
below.
Machine
Setups
Copy
Setups
Fax
Setups
Print
Setups
Scan to
File
Setups
Key
Operator
System
Administrator
Auditron
Administrator Owner
Yes No No No
Yes No No No
Yes No No No
No Yes No No
No Yes No No
Page 10-86 Xerox Document Centre 440/432/420 User Guide