Xerox Document Centre 440/432/420 User Guide

Fault Override
Accessing Fault Override
When a fault occurs on the DC440/432/420, the Touch Screen
displays step-by-step instructions for the walkup user to clear
the fault. The instructions include contacting the Key Operator
if the fault cannot be cleared.
In this instance the Key Operator can enter their PIN to access
the Fault Override screen and disable the faulty component.
After the component is disabled, all features will be available
except those that require the disabled component.
Use Fault Override only if all other attempts to clear the fault
have failed. Entering Fault Override Mode might require action
to disable the faulted component, delete the faulted job, or
both, depending on the type of job and fault.
NOTE: Use caution when deleting a remote job - it may not be
possible to re-create or resubmit the job.
To access Fault Override Mode, a fault screen must currently
be displayed on the Touch Screen.
� Select [Access]
� Select [#] and enter a PIN (Personal identification Number)
with Key Operator access rights - see NOTE below.
� Select [Confirm] to delete the current job and or disable the
faulty component.
NOTE: The default password - #22222 - may be used if PINs
have not been assigned. Refer to “Access Rights” on page 10-
86 for more information.
Page 10-20 Xerox Document Centre 440/432/420 User Guide