TIRE MAINTENANCE MANUAL - Goodyear Off-The-Road (OTR)

Use mmechaniicall aids when removing
heavvy rim componeents.
DDeemounntinng toools appllyy hiigh presssure to
rim flanges when uunnseating tire beads.
PRECAUTION
Cllean and repaint rims. This will stop
corroosion. It will also make it easier to
moount and check components.
Cleann dirt andd rust froom lock ring and
gutteer.
Airr inflaation equipment should have a
filter inn the air line. Filter must be
checked frequently to see that it works
properly.
Checck rim componeents for cracks
Replace all componentss whichh are:
• Cracked
• Baadly worn
• Damagedd
• Severely rusteed
Use neew compponent of same size and
typpe. Replacement parts must not be
crackked, broken or daamaged.
INSPECTION
27
This will help protect you from injury.
A dropped flange can crush a hand or foot.
Attempting to grab a falling flange or bead
seat can cause serious injury.
If tool slips, it can fly with enough force to
cause severe injury or death. Keep fingers
clear. Always stand to one side when you
apply pressure.
REASON FOR PRECAUTION
Parts must be clean for proper fit. This is
especially true of the gutter section which
holds lock ring in position.
This is important to seat the lock ring
properly.
This will prevent moisture from entering
the tire and prevent corrosion.
Parts that are cracked, damaged or excessively
rusted are weakened. Bent or
repaired parts may not engage properly.
This allows for proper fit and function.