Nimbus Compact M NET R32 Installation Manual UK

Commissioning
1.23 DOMESTIC HOT WATER - 2
1.23.0 Thermal Cleanse target temp
Defines the setpoint of thermal cleanse cycle.
1.23.1 Antilegionella target temperature duration
Defines the time in which the Thermal cleanse Target temp has
to be mantained.
1.23.2 Max Duration Antilegionella
Defines the Max time in which the system can perform and
complete the Thermal cleanse cycle.
1.24.4 Backup electric heaters nominal power
Backup Heating Element Nominal Power Consumption.
1.24.5 Tank electric heaters nominal power
Tank electric heaters nominal power consumption.
1.24.6 Backup electric heaters efficiency
Backup Heating Element Nominal efficiency.
1.24.7 Tank electric heaters efficiency
Tank electric heaters nominal efficiency.
1.24 ENERGY METER
1.24.0 Energy pulse unit
Press the selector . Turn the selector to choose the desired
item.
Define if the S0 input is used or not:
0 None: S0 signal input is not used.
1 kWh: S0 signal input is used.
Press the selector to confirm.
1.24.1 Energy pulse value number
1.24.2 Energy pulse value factor
The multiplication of Energy pulse value factor and the Energy
pulse value number gives the number of pulses representing
an energy consumption of 1 kWh. These parameters must be
set according to the connected pulse meter. Specifications.
Press the selector . Turn the selector to choose the desired
item.
0 /1000
1 /100
2 /10
3 1
4 x10
5 x100
6 x1000
Press the selector to confirm.
1.24.3 Energy pulse measuring type
Defines if the S0 input signals measures the HP consumption
(0) or the sum HP and resistors consumption (1).
Press the selector . Turn the selector to choose the desired
item.
0 Only HP.
1 HP + Electric Heater.
Press the selector to confirm.
EN / 57