Nimbus Compact M NET R32 Installation Manual UK

1. Safety advices
1.1 General warnings and safety instructions
i
i
i
i
This manual is the property of ARISTON and it
is forbidden to reproduce or transfer to third
parties the contents of this document. All
rights reserved. This document is an integral
part of the product; make sure that it always
accompanies the appliance, also when the
latter is sold/transferred to another owner, so
that it can be consulted by the user or by personnel
authorised to perform maintenance
and repairs.
Read the information and warnings given in
this manual in full; they are essential to the
safe installation, use and maintenance of the
product.
It is forbidden to use this product for purposes
and in conditions other than those specified
here. The manufacturer shall not be held
liable for any damages due to improper, incorrect
or unreasonable use or due to failure
to comply with the instructions and
warnings contained in this manual.
It is forbidden to use this product in combination
with electrical and electronic appliances
or with accessories not manufactured
and/or not authorised by the manufacturer
that can alter the conditions guaranteeing
conformity to the legal requirements and/or
the relevant technical regulations or that can
alter the safety and/or operating conditions
and/or performances of the product itself,
thus invalidating the product’s conformity
marking (e.g. CE mark or other conformity
marks of the product).
i
i
i
i
i
i
i
i
Safety advices
In particular, it is forbidden to install on the
proprietary BUS access port electrical and
electronic appliances not manufactured
and/or not authorised by the manufacturer.
It is also forbidden to make changes to
the product’s software programme for the
above-mentioned reasons and for the potential
consequences thereof, including the invalidation
of the product’s conformity marking
(e.g. CE mark or other conformity marks
of the product).
The manufacturer declines all liability deriving
from the use of the product if the above
warnings are not observed.
All routine and extraordinary maintenance
operations, such as breaking into the refrigerating
circuit and opening of sealed
components, must be carried exclusively by
qualified personnel exclusively using original
spare parts. The manufacturer is not liable for
damage resulting from failure to observe this
instruction, which may compromise the safety
of the installation.
Product dismantling and recycling operations
must be carried out by qualified technical
personnel.
At all times the manufacturer’s maintenance
and service guidelines shall be followed. If in
doubt, consult the manufacturer’s technical
department for assistance.
Make sure the installation site and any systems
to which the appliance must be connected
comply with applicable regulations.
The appliance is configured for connecting
directly to the water mains.
4 / EN