Nimbus Compact M NET R32 Installation Manual UK
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Hydraulic connections<br />
4. Hydraulic connections<br />
4.1 Indoor unit hydraulic connections<br />
Preliminary checks:<br />
a<br />
– Check that the system has been cleaned;<br />
– Check that there are no impurities in the circuit water;<br />
– Check that compatible components are used (e.g. do<br />
not connect copper and steel to each other);<br />
– Check that the connection to the heating system has<br />
been made correctly;<br />
– check that the water supply distribution network pressure<br />
does not exceed 0.5 MPa (5 bar), otherwise install a<br />
pressure reducer at the system's intake;<br />
– check that a disconnect device with cock is installed<br />
between the system and the domestic water supply<br />
distribution network (if present);<br />
– check that the supplied expansion vessel is large<br />
enough to handle the water in the system and, if necessary,<br />
install an additional one;<br />
Remove the rubber protective caps before making<br />
the hydraulic connections. The plugs are<br />
used exclusively as a protective device during<br />
transport.<br />
After the checks:<br />
Z1<br />
OUT<br />
1<br />
2<br />
3<br />
B<br />
7<br />
4<br />
5<br />
IN<br />
A<br />
6<br />
8<br />
OUT<br />
Z1<br />
IN<br />
Fig. 41<br />
(*) If recirculation is used, remove the brass plug before using<br />
the connection<br />
1-ZONE configuration<br />
– Mount the quick couplings (present inside the machine)<br />
on the water pipes (1), (3), (7) and (8).<br />
8<br />
1<br />
7<br />
3<br />
Fig. 40<br />
Consider the following hydraulic connections:<br />
– System flow (1)<br />
– Safety valve drain (2)<br />
– Delivery to heat pump (3)<br />
– Recirculation (4) (if present) (*)<br />
– Domestic hot water return (5)<br />
– Domestic hot water flow (6)<br />
– System return (7)<br />
– Return from heat pump (8).<br />
EN / 25