Nimbus Compact M NET R32 Installation Manual UK
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Installation</strong><br />
– Attach the tray using the appropriate hooks (5).<br />
– Fasten the tray with the screws (3) and (4) removed<br />
previously.<br />
5<br />
5<br />
2<br />
3<br />
4<br />
4<br />
3<br />
Fig. 36<br />
3.4 Installing the indoor unit<br />
Fig. 33<br />
– To ensure correct operation of the kit, the unit must rest<br />
on a base measuring at least 70 mm.<br />
3.4.1 Place of installation<br />
To position the system, use the template provided and a spirit<br />
level.<br />
To avoid jeopardising the product’s operation, the place of<br />
installation must be adequate in relation to the threshold operating<br />
temperature (min +5°C) and protected against direct<br />
contact with atmospheric agents.<br />
Minimum installation distances<br />
H≥70<br />
mm<br />
Fig. 34<br />
350<br />
mm<br />
Condensate collection tray heating element<br />
– Position the heating element (1) on the bottom of the<br />
unit.<br />
350<br />
mm<br />
400<br />
mm<br />
1<br />
800<br />
mm<br />
Fig. 35<br />
– Pass the power cables (2) of the heating element<br />
through collar (3), cable hole (4) and collar (5).<br />
– To connect the heating element electrically, refer to the<br />
paragraph “Electrical connections”.<br />
i<br />
Fig. 37<br />
If the DHW Expansion Vessel is installed, it is necessary<br />
to leave a gap of at least 50 mm from the<br />
rear wall.<br />
EN / 23
Change language