Kitchen worktops by Getalit - Kitchen Fit Sandiacre
Kitchen worktops by Getalit - Kitchen Fit Sandiacre
Kitchen worktops by Getalit - Kitchen Fit Sandiacre
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
34<br />
protected with moisture-resistant paper<br />
foil. Moisture-resistant seal at joint along<br />
front edge.<br />
� AF 40/133 Hydro<br />
38 mm moisture-resistant chipboard type<br />
P3 (hydrofuge) to DIN EN 312, face side<br />
and front edge faced with 0.7 mm GetaLit<br />
(HPL), front (and back) edge postformed<br />
– radius 4 mm, reverse side and rear edge<br />
protected with moisture-resistant paper<br />
foil. Moisture-resistant seal at joint along<br />
front edge.<br />
ACCESSORIES<br />
� PP-/Effect-Edges<br />
1,5 / 2 mm decor matching PP-edges<br />
for an individual style of the worktop.<br />
protected with moisture-resistant paper<br />
foil. Moisture-resistant seal at joint along<br />
front edge.<br />
� AF 40/113 Hydro Bril<br />
38 mm moisture-resistant chipboard type<br />
P3 (hydrofuge) to DIN EN 312 , face side<br />
and front edge faced with 0.8 mm GetaLit<br />
(HPL) in Brilliant Gloss finish, front edge<br />
postformed – radius 7 mm. Reverse side<br />
and rear edge protected with moisture-<br />
resistant paper foil. Moisture-resistant<br />
seal at joint along front edge. Surface<br />
foil-protected.<br />
� GetaLit Flex edges<br />
Two layer polyester based continuous<br />
laminate (colour co-ordinated). Type<br />
SB = Reverse with hot-melt adhesive<br />
(marking: red) Type G = Smooth reverse<br />
for hot-melt adhesive (marking: yellow)<br />
Reverse side and rear edge protected with<br />
moisture-resistant paper foil. Moisture-<br />
resistant seal at joint along front edge.<br />
Surface foil-protected.<br />
� Cut and edged <strong>worktops</strong><br />
All worktop versions are also available as<br />
cut-and-edge.<br />
� GetaLit edges<br />
High-pressure decorative laminate edges<br />
according to DIN EN 438.<br />
��������������������������������������������������� ����������������