International Catalogue Vol 22.2

SUSPENSION - TECHNICAL SPECIFICATIONS
Installation Form
SUSPENSION INSTALLATION FORM IRONMAN 4X4
IRONMAN 4X4 SUSPENSION INSTALLATION FORM
Please copy and complete this form at the time of installation.
Keep in a safe place for future reference.
Always ensure you have all the correct parts before beginning installation.
Installing suspension often requires special tools and expert knowledge. All fitment should be performed by a qualified and experienced fitter.
Always tighten bushed components after the vehicle is let down onto the ground at normal ride height, otherwise damage from torsional stresses can occur.
Ironman 4x4 recommends a wheel alignment after fitment of new suspension, consideration to natural spring settling should be taken into account before alignment is done.
Always adhere to vehicle manufacturers torque specification when tightening fasteners.
Always grease polyurethane bushes prior to fitment, Ironman 4x4 recommends a molybdenum based grease or grease specified for polyurethane.
If necessary, brake proportioning valve should only be adjusted and tested by a qualified brake specialist.
Further ADAS safety systems may need to be recalibrated by a qualified service technician.
YOUR DETAILS
Name:
Email:
Phone:
Invoice:
VEHICLE DETAILS
Make: Model: VIN / Reg No:
Odometer:
Engine Type:
Pre-Existing Modifications (Please Circle Items Fitted)
No Accessories
Bull Bar
Winch
Underbody Protection
Recovery Points
Side Steps
Side Rails
Tow Bar Only
Long Range Fuel Tank
Slide-Away Roll Up Tonneau
Awning
Rooftop Tent
Body Type:
Rear Drawers
Fridge
Dual Battery System
Roof Rack
Canopy
Service Body
Rear Protection Bumper
Water Tank
SUSPENSION COMPONENT DETAILS
Item Part No. Batch No. Item Part No. Batch No.
1
11
2
12
3
13
4
14
5
15
6
16
7
17
8
18
9
19
10
20
NOTES AND COMMENTS
SUSPENSION MEASUREMENTS
Actual Spring Measurements (mm)
Left Side
Front
SPRINGS
Free Height Camber
mm
Rear
Right Side
Pre-Fitment Measurements (mm)
Rim to Guard
Left Side
Front
BEFORE
Wheel Rim Size
mm
Rear
Right Side
Post-Fitment Measurements (mm)
(After Product Fitment) Rim to Guard
Ensure this is completed after a test drive and on a level surface
Left Side
Right Side
Front
AFTER
Test Drive
mm
Rear
POST INSTALLATION INSPECTION
TICK
All fitting, fasteners and wheels have been
tensioned to the correct manufacturers
specifications and marked with a paint pen
where appropriate.
PRINT NAME
INSTALLERS NAME:
SIGNATURE:
DATE OF INSPECTION:
PRINTED FORM COMPLETED AND UPLOADED INTO ONLINE SUSPENSION FORM
COMPLETED:
All measurements to be taken prior to installation, immediately after initial test drive and again at 500km check.
All vehicle height measurements to be taken from lower of wheel rim to guard unless otherwise stated.
Up to 10mm height reduction in springs can be considered normal settling over time.
Suspension product warranty period is 4 years or unlimited km, GVM warranty period is 2 years or 40,000km unless otherwise stated.
SIF/281122 Rev.5
Ironman 4x4 Product Catalogue - Volume 22.2 (International)
437