z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY MONITOR
If QUERY MONITOR PARTITION is specified, the response is:
MONITOR PARTITION n
PARTITION n
indicates the number of 4 KB pages allocated to hold for event configuration
and data records.
Response 6 (RATE):
If QUERY MONITOR RATE is specified, the response is:
MONITOR RATE {m SECONDS} [PENDING RATE {n SECONDS}]
{STOP } { STOP }]
RATE n SECONDS
RATE STOP
describes the current monitor high-frequency sampling rate, where n is a value
between 0.01 and 30 seconds. STOP indicates that high-frequency sampling is
inactive.
PENDING RATE n SECONDS
PENDING RATE STOP
indicates that a new high-frequency sampling rate is to take effect after the
current high-frequency sampling rate has occurred, where n is a value between
0.01 and 30 seconds. STOP indicates that high-frequency sampling becomes
inactive when the current RATE expires.
Response 7 (SAMPLE):
884 z/VM: CP Commands and Utilities Reference
If QUERY MONITOR SAMPLE is specified, the response is:
MONITOR SAMPLE {ACTIVE }
{INACTIVE }
{SUSPENDED }
{PENDING }
INTERVAL {n MINUTES} [PENDING INTERVAL {n MINUTES}]
{n SECONDS} [ {n SECONDS}]
RATE {n SECONDS} [PENDING RATE {n SECONDS}]
{STOP } [ { STOP }]
MONITOR DCSS NAME - {dcssname }
{NO DCSS NAME DEFINED}
CONFIGURATION SIZE n LIMIT {n MINUTES}
{n SECONDS}
CONFIGURATION AREA {WILL BE FREED WITHIN - {n MINUTES n SECONDS}}
{IS FREE}
USERS CONNECTED TO *MONITOR {NO USERS CONNECTED }
{userid[QUIESCED][PROCESSING-CONFIG][EXCLUSIVE]}
[PENDING-CONFIG ]
SAMPLE
describes the status of sample monitoring.
ACTIVE
indicates that SAMPLE monitoring is being performed because a MONITOR
START or MONITOR SAMPLE START command was issued and there are
eligible monitor users to receive sample data notification messages.
INACTIVE
indicates that SAMPLE monitoring is not being performed because no
monitor start command for a sample has been issued.