z/VM: CP Commands and Utilities Reference - z/VM - IBM

Messages
The router line is displayed only when a router is configured.
Options
options indicates the currently enabled features for this interface, such as
Broadcast, Multicast, IPv4 or IPv6.
ipaddr
represents one Unicast IP address that has been registered to this device and
optional information relating to the IP address.
An IPv4 address is displayed in dotted-decimal format, for example
9.130.44.144.
An IPv6 address is displayed in compressed format (“::” designates multiple
16-bit groups of zeros). For example, the IPv6 address
F802:0000:0000:0000:0000:0000:0A00:0001
is displayed in compressed format as F802::A00:1.
mpaddr
represents one Multicast IP Address.
For IPv4, the address is displayed in dotted-decimal format with the associated
MAC address.
For IPv6, the address is displayed in compressed format (“::” designates
multiple 16-bit groups of zeros).
MAC
macaddr represents a MAC address.
flags
additional information that may be displayed with the IP address. These include:
HCP2783E LAN ownerid lanname does not exist
HCP2836E VLAN was not found
QUERY LAN
v Remote indicates that this address was registered automatically to represent
a source address found in a datagram. This entry is automatically removed
after the IP Timeout (IPTimeout) has expired.
v Disabled indicates that this address was registered, but is no longer active.
This may happen when a second guest registers this same address with
options that permit IP Takeover.
v Manual indicates that this address was registered manually by an ARP cache
control command from the driver. This entry will be automatically removed
after the IP Timeout (IPTimeout) has expired, or it may be removed earlier by
the driver.
Chapter 2. CP Commands 841