z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY GRAF
response following this line. The numbers WGU9E316 and TN6PV192 identify
SNA/CCS terminals controlled by a VTAM service machine. They are the names
from the VTAM definition of the terminals as SNA logical units. DONNA and CORAK
are the users logged on through VTAM. Each has 0009 as the virtual console
device number.
Response 3:
If you enter a QUERY GRAF BOXED, QUERY GRAF FREE, or QUERY GRAF
OFFLINE command, you see something like this:
q graf free
GRAF 08E1 ENABLED, GRAF 08E2 ENABLED, GRAF 08E3 ENABLED, GRAF 08E4 ENABLED
GRAF 08E5 ENABLED, GRAF 08E6 ENABLED, PRT 08E7 ENABLED, GRAF 0BC0 ENABLED
GRAF 0BC1 ENABLED, GRAF 0BC2 ENABLED, GRAF 0BC3 ENABLED, GRAF 0BC4 ENABLED
GRAF 0BC5 ENABLED, GRAF 0BC6 ENABLED, GRAF 0BC7 ENABLED, GRAF 0BC8 ENABLED
Ready;
The word ENABLED might be replaced by OFFLINE, FREE, or BOXED, depending
on what you entered.
Response 4:
If you enter a QUERY GRAF ALL command, CP displays all the responses as if you
had entered QUERY GRAF ACTIVE, QUERY GRAF FREE, and QUERY GRAF
OFFLINE commands.
Response 5:
If CP cannot find a graphic display device of the type you specified, you see a
message like this:
q graf boxed
A BOXED display was not found.
Ready;
In this response, BOXED may be replaced with active, attached, free, or offline,
depending on what you specified on the command.
Response 6:
If you enter a QUERY GRAF, QUERY GRAF ACTIVE, or QUERY ALL command
with the EXTended option, the response shows the fully qualified logical unit name
and might look something like this:
Q GR EXT
GRAF 03E0 DIALED TO VTAM 03E0
GRAF 03E1 DIALED TO VTAM 03E1
VTAM CONTROLS THE FOLLOWING LU’S
GRAF VTAM1.LU3E0 LOGON AS CMS0001 03E0
GRAF VTAM1.LU3E1 LOGON AS CLASSG 03E0
If instead you enter a QUERY GRAF, QUERY GRAF ACTIVE, or QUERY ALL
command without the EXTended option you might see something like this:
Q GR
GRAF 03E0 DIALED TO VTAM 03E0
810 z/VM: CP Commands and Utilities Reference