z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY EXITS
Messages
HCP002E Invalid operand - operand
v Entered and exited this exit point 3 times, which means the exit point is not
currently active.
v Used a little less than 1 millisecond to set up this exit point and process all calls
to its associated entry point.
The next five lines show that:
v The exit point was defined dynamically.
v The exit point is located at 4 bytes past entry point HCPXMGMS, where
instruction X'41700000' occurs.
v The resolution of the entry point associated with the exit was performed when the
association was made between them.
v The exit point was defined by user OPERATOR on September 3, 1998, at
13:27:54 local time.
v The exit receives two parameters, namely the contents of general registers 9 and
12 at the point of exit, in addition to the three parameters that are passed to
every dynamic exit.
The last two lines show that:
v Exit point X'1234' currently has 1 entry point (EXITSTDP).
v CP tried to call EXITSTDP 3 times and succeeded in each case.
HCP003E Invalid option - command contains
extra option(s) starting with option
HCP013E Conflicting option - option
HCP2752E The variations of this message are as
follows:
v Exit number exit does not exist
v Exit numbers exit1-exit2 do not exist
v Exit numbers do not exist
HCP6704E Missing token at end of line
HCP6706E Invalid CP Exit number - exit
794 z/VM: CP Commands and Utilities Reference