z/VM: CP Commands and Utilities Reference - z/VM - IBM

QUERY CONFIGMODE
Messages
To display whether your processor is currently in configuration mode, enter the
following:
query configmode
System is not in configuration mode.
Ready;
This response tells you that your processor is not currently executing commands to
dynamically change its I/O configuration.
Response when Configuration Mode is Turned On:
If someone on your system had turned configuration mode on using the SET
CONFIGMODE command and was in the process of issuing one or more dynamic
I/O commands, you would see the response below. You would also see this
response if someone on your system had issued a dynamic I/O command that
caused the system to temporarily turn on configuration mode:
query configmode
System is in configuration mode for user userid
Ready;
Where userid is the name of the person who issued the SET CONFIGMODE
command.
HCP003E Invalid option - command contains
extra option(s) starting with option
HCP6808E System disabled for dynamic I/O
changes
v The configuration mode setting of
the hardware and software do not
match
v The dynamic I/O support was
disabled at the service console
v Cannot store LPAR data
v The VM configuration token does
not match the hardware configuration
token
v Cannot find the configuration token
on the system
HCP6809E This processor does not support
dynamic I/O changes
HCP6815E Command failed in the channel
subsystem
718 z/VM: CP Commands and Utilities Reference
HCP6816E Dynamic I/O changes are not allowed
on this system