z/VM: CP Commands and Utilities Reference - z/VM - IBM

Messages
PRIVCLASS 12345678 * C C
PRIVCLASS 76543218 * 0 GZ
------------ 58281098 * 0
Ready;
Issuing the LOCATE CMDBK commands before and after your MODIFY
COMMAND command is not necessary, but it shows you how the command
definition has changed.
Response 3:
HCP002E Invalid operand - operand
To change all IBM class E QUERY subcommands to privilege class G, enter the
following:
modify cmd query subcmd * ibmclass e privclasses g
Ready;
The preceding command does not change any QUERY VIRTUAL subcommands. To
change them, enter the following:
modify cmd query virtual subcmd * ibmc e priv g
Ready;
HCP003E Invalid option - command contains
extra option(s) starting with option
HCP013E Conflicting option - option
HCP770E MODIFY is not valid for command
{command|QUERY subcommand|SET
subcommand}
HCP770E MODIFY is not valid for command
{command|QUERY subcommand|SET
subcommand} because different
EPNAMEs would be set
HCP770E MODIFY RESET is not valid for
command {command|QUERY
subcommand|SET subcommand}
because different EPNAMEs would be
set
HCP6704E Missing token at end of line
HCP6706E The variations of this message are as
follows:
v Invalid privilege classes - classes
v Invalid command name - command
MODIFY COMMAND / CMD
v Invalid subcommand name -
subcommand
v Invalid entry point name - epname
v Invalid IBM class - c
HCP6841E You did not specify an IBM class for
command command
HCP6842E Cannot find existing CP command
HCP6845E You must specify a privilege class
other than 0
Chapter 2. CP Commands 603