z/VM: CP Commands and Utilities Reference - z/VM - IBM

DISABLE EXITS
Responses
Messages
7. To display the real address of the CP indirect call locator block for a specific
exit point, use the LOCATE ICLBK command (page 539).
8. To change the definition of an existing dynamic exit point, or to remove the exit
point from the system, use the MODIFY EXIT command (page 618).
9. To remove the exit point code from CP’s system execution space, use the
CPXUNLOAD command (page 107).
10. After processing a DISABLE EXITS command (or statement), CP updates the
status of the exit point in its CP exit block, but does not erase the CP exit
block. CP will not erase any CP exit blocks until the next IPL.
11. For more information about user-defined exit points, see the z/VM: CP Exit
Customization book.
Response 1:
To stop CP from calling the entry points and external symbols associated with CP
Exits 1, 2, 3, 4, and 6, enter the following:
disable exits 1-4 6
Ready;
Response 2:
To stop CP from calling the entry points and external symbols associated with all
CP exit points, enter the following:
disable exits all
Ready;
HCP002E Invalid operand - operand
HCP2752E The variations of this message are as
follows:
v Exit number exit does not exist
v Exit numbers exit1-exit2 do not exist
v Exit numbers do not exist
HCP6704E Missing token at end of line
HCP6706E Invalid CP Exit number - exit
270 z/VM: CP Commands and Utilities Reference