z/VM: CP Commands and Utilities Reference - z/VM - IBM

CCLOAD
CCLOAD
►►
CCLOAD
Purpose
Operands
Options
vdev
lmod
CMD (command)
Yes
DUMP
No
Prompt
LIBe loadlib
NOMONitor
No
RELoad
Prompt
Yes
1770 z/VM: CP Commands and Utilities Reference
Use CCLOAD to provide support for loading and dumping a communication
controller manually, or from a service virtual machine.
vdev
identifies the virtual device to which the base subchannel for loading and
dumping the communication controller is dedicated or attached.
lmod
identifies the member of the emulation program (EP) load module to be loaded
from the OS format LOADLIB created by the generation process.
CMD command
specifies a command to be processed when the controller is loaded and ready
for use. For example, you can notify the VM/Pass-Through Facility (PVM) to
start its remote line drivers by specifying cmd(cp smsg pvm exec ep01) where
EP01 PVM is a file containing PVM start commands.
DUMP Yes
DUMP No
DUMP Prompt
specifies whether the controller is automatically dumped when an EP control
program failure is detected. If PROMPT is specified, the user is asked to decide
whether to take the dump. If NOMONITOR is specified, the DUMP operand is
ignored.
LIBe loadlib
specifies the file name of the file type LOADLIB that contains the load module.
If not specified, lmod is assumed.
NOMONitor
specifies that the command is to load the controller only, then end without
monitoring controller and console interrupts. If not specified, the command
monitors the controller and console for interrupts. A console attention interrupt
results in prompting for a user decision on whether to dump and/or reload the
controller, end the command, or ignore the attention.
►◄