z/VM: CP Commands and Utilities Reference - z/VM - IBM

Messages
HCP002E Invalid operand - operand
No response is issued when TRSAVE FOR ID traceid commands complete
because, while TRSAVE defines the destination of traces defined by TRSOURCE,
recording of those traces is started and stopped by the ENABLE and DISABLE
parameter of the TRSOURCE command.
With both the TRSAVE function completed and the TRSAVE function canceled
responses, the trace service tool function is turned off. The second of these
responses is issued only when DASD was specified on the TRSAVE ON command.
(It is not issued for CP traces to tape.)
HCP003E Invalid option - {option|command
contains extra option(s) starting with
option}
HCP006E Invalid device type - {rdev|vdev|ldev}
HCP013E Conflicting option - option
HCP020E Userid missing or invalid
HCP021E A real device number was not supplied
or it is invalid.
HCP026E Operand missing or invalid
HCP040E Device {rdev|vdev|ldev} does not exist
HCP046E type rdev offline
HCP053E [XAUTOLOG failed for userid:]
userid|value not in CP directory
HCP140E type {rdev|ldev} attached to userid
HCP143E type rdev in use by system
HCP410E CP ENTERED; PAGING ERROR
HCP422E The same option was specified twice.
HCP423E The function requested is incompatible
with a previously specified operand.
HCP475I Fatal I/O error trying to read directory
from volid [for user userid]
HCP479E Traceid traceid currently enabled
HCP1001E An operand is missing for option.
HCP1013E An invalid operand was supplied for
option - operand.
HCP1105E Tape rdev not attached; tape assigned
elsewhere.
HCP1107E command failed; I/O error on tape rdev
HCP1917E Tape device(s) {rdev[-rdev]|vdev[-vdev]}
attached MULTIUSER.
HCP6076E TRSAVE is not active.
HCP6077E TRSAVE is already active.
TRSAVE
HCP6079E Tape drive rdev does not support mode
mode.
HCP6085E The TRSAVE command cannot be
processed because the function is in a
transition state.
HCP6087E DEFERIO FRAMES specified exceeds
the amount of frames eligible for
DEFERIO traces.
HCP6089E DEFERIO FRAMES specified causes
total DEFERIO frames to exceed the
amount of frames eligible for all
DEFERIO traces.
HCP6091I The amount of frames used for
DEFERIO trace exceeds the amount of
pages that will be saved on DASD.
HCP6099E DEFERIO trace is invalid for a TYPE
GT BLOCK mode trace.
Chapter 2. CP Commands 1671