z/VM: CP Commands and Utilities Reference - z/VM - IBM

TRACE APPEND
►►
TRace
Authorization
Purpose
Operands
APPEND
Usage Notes
Responses
name
Privilege Class: G
Use TRACE APPEND to merge the trace traps from two trace sets into one.
name
specifies the trace set whose traps are to be merged into the current trace set.
1. The TRACE APPEND command causes all trace traps from the named trace
set to be added to the current trace set.
If a trap exists in both trace sets with the same identifier and the trap was
named using the ID option on the TRACE command, the trap in the named set
replaces the trap in the current trace set.
If two traps have the same identifier but were not named with the ID option (for
example, the identifier was assigned by the system), both traps remain, and the
trap from the named trace set is assigned a new identifier.
2. The current trace set cannot be appended to itself.
3. For more information, see “Usage Notes” on page 1601.
TRACE APPEND
For response information, see “TRACE: Command Responses” on page 1610.
►◄
Chapter 2. CP Commands 1621