z/VM: CP Commands and Utilities Reference - z/VM - IBM

TRACE: Options
v PASS 8 displays every ninth event
v SKIP 2 PASS 8 displays the third event, the twelfth event, and every ninth
event thereafter.
STOP n
requests a number of displays for the command. Your virtual machine pauses
after the specified number of displays. Unless a STEP count is specified, a
pause occurs for each subsequent display.
STEp n
is a repeating STOP specification. If you do not specify a STOP option, STEP
takes effect immediately. If you do specify a STOP count, STEP takes effect
after the first pause.
For example:
v STEP 3 pauses every third event
v STEP 9 pauses every ninth event
v STOP 3 STEP 9 pauses after the third and twelfth displays and for every
ninth display thereafter.
TErminal
specifies that output for the current command be sent to the virtual console.
This is the default setting for newly created tracing specifications with neither
terminal nor printer output specifications. TERMINAL and NOTERMINAL are
incompatible options.
NOTERMinal
specifies that output for the current command is not to be sent to the virtual
console. TERMINAL and NOTERMINAL are incompatible options.
BOth
specifies that the output for the current command be sent to the virtual console
and to the virtual printer.
Printer
specifies that output for the current command be sent to the virtual printer
having the lowest virtual device number. PRINTER may be abbreviated to PRT;
PRINTER and NOPRINTER are incompatible options.
NOPRINTer
specifies that output for the current command is not to be sent to the virtual
printer. NOPRINTER may be abbreviated to NOPRT; PRINTER and
NOPRINTER are incompatible options.
SUPervisor
requests that the specified tracing be restricted to events occurring while the
machine is in supervisor state. If specified in addition to PROBLEM, or if neither
SUPERVISOR nor PROBLEM is specified, both problem state and supervisor
state events are traced.
PROBlem
requests that the specified tracing be restricted to events occurring while the
machine is in problem state. If specified in addition to SUPERVISOR, or if
neither SUPERVISOR nor PROBLEM is specified, both problem state and
supervisor state events are traced.
DAT
requests that the specified tracing be restricted to events occurring while the
virtual machine has virtual dynamic address translation enabled. If you specify
DAT in addition to NODAT, or if you specify neither DAT nor NODAT, events
occurring in both DAT and non-DAT mode are traced.
Chapter 2. CP Commands 1607