z/VM: CP Commands and Utilities Reference - z/VM - IBM

DEFINE
HCP6005E Option option is not supported by z/VM.
HCP6704E Missing token at end of line
HCP6706E The variations of this message are as
follows:
v Invalid file name - fn
v Invalid number - nnnn
v Invalid time zone offset - offset
v Invalid time zone ID - zoneid
v Invalid volume label - volid
v Invalid privilege classes - classes
v Invalid command name - command
v Invalid subcommand name -
subcommand
v Invalid entry point name - name
v Invalid Diagnose code - diag
v Invalid alias name - alias
v Invalid IBM class - c
v Invalid routine name - routine
v Invalid exit number - exit
v Invalid instruction - instruction
HCP6779E Volume volid already defined in slot nnn
HCP6780E Slot number cannot exceed the defined
maximum of mmm
HCP6781E Requested slot occupied by mounted
volume volid
116 z/VM: CP Commands and Utilities Reference
HCP6789E The variations of this message are as
follows:
v Diagnose code diag is already
defined
v Requested CP Exit number exit is
already defined
HCP6805E The variations of this message are as
follows:
v Cannot find RDEV for TYPE 1
subchannel
v Cannot determine partition being
changed by this dynamic I/O request
HCP6806E Dynamic I/O change request [for
channel path|for control unit|for
device] failed with return code nnnn
HCP6809E This processor does not support
dynamic I/O changes
HCP6815E Command failed in the channel
subsystem
HCP6816E The variations of this message are as
follows:
v Dynamic I/O changes are not
allowed on this system
v Dynamic I/O changes are not
allowed for device rdev
v Dynamic I/O changes are not
allowed because LPAR information is
not available
v Dynamic I/O changes are not
allowed because the configuration
token is not a valid VM token
v Dynamic I/O changes are being
controlled by HCD