z/VM: CP Commands and Utilities Reference - z/VM - IBM

SET RDEVICE Communication Controllers
Usage Notes
Examples
Responses
Messages
1. Of the 3705, 3725, and 3745, 3705 is the only one that does not respond to a
sense ID request. You must, therefore, define it with either a SET RDEVICE
command or an RDEVICE statement in the system configuration file.
Example 1:
To specify an IBM Terminal Adapter Type 1 at device number 01F0, enter the
following SET RDEVICE command:
set rdevice 01F0 type ibm1_adapter
Example 2:
HCP002E Invalid operand - operand
To specify three Binary Synchronous Terminal Control Type II adapters at device
numbers 01F1, 01F2, and 01F3, enter this SET RDEVICE command:
set rdevice 01F1-01F3 type bsc_adapter
After CP has issued a message for each device address affected by a SET
RDEVICE command, the following summary response is displayed:
xxx RDEV(s) specified; yyy RDEV(s) changed; zzz RDEV(s) created
HCP003E Invalid option - command contains
extra option(s) starting with option
HCP6000E The range of device numbers cannot
exceed 256.
HCP6704E Missing token at end of line
HCP6706E Invalid address range - range
1344 z/VM: CP Commands and Utilities Reference